Engine Thrust 0/0

[Wayne Galligan]

 Here is another link on Chips throttle to rudder mix ideas.

http://www.rcuniverse.com/forum/m_1662739/tm.htm

WG


  ----- Original Message ----- 
  From: Wayne Galligan 
  To: discussion at nsrca.org 
  Sent: Monday, November 07, 2005 10:42 AM
  Subject: Fw: Engine Thrust 0/0





  Vincent,

  I think Chip uses about 2 degrees or as little as possible and then adds a throttle to rudder mix curve.

  Chip had an article on this on RcUnivrese under his forum.
  http://www.rcuniverse.com/forum/m_2454017/tm.htm

  Wayne G

    ----- Original Message ----- 
    From: vicenterc at comcast.net 
    To: NSRCA 
    Sent: Monday, November 07, 2005 8:38 AM
    Subject: Engine Thrust 0/0


    Finally, I had chance to read the last K-Factor (October).  I read an article Practice and Trimming by Scott Covey (District 7 column) and it was interesting the information in regard 0/0 engine trust.  However, it does gives too much details besides that the results were good.  I remember checking Chip Hyde Scandalous at Nats. and I don't think I could see 0/0.  At naked eye it was evident that it has right thrust.  I am interesting in finding real feedback from experience pattern pilots using 0/0 engine thrust.

    Best regards,

    Vicente Bortone
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20051107/8e9b225d/attachment.html