YS 140 Help

[hotrod34a at aol.com]

Randy,
>From our experience and our climate, it just performs a lot better with 30%.  I have used 20% in the fall and early spring with no problems, but when the weather here turns warmer, it just pulls a lot stronger,  Larry.... 
 
-----Original Message-----
From: Randy <randy10926 at comcast.net>
To: discussion at nsrca.org
Sent: Mon, 2 May 2005 19:07:14 -0400
Subject: Re: YS 140 Help


Does a YS140 sport really need 30% to run right?
Randy
----- Original Message ----- 
From: hotrod34a at aol.com 
To: discussion at nsrca.org 
Sent: Monday, May 02, 2005 7:08 AM
Subject: Re: YS 140 Help


Jerry,
We have quite a few Sports in our club, and all of us are running the 30% nitro, especially in the warmer weather.  They are a little sensitive on the needle valve setting.  We had a situation here where our engines started doing basically the same thing that you described, start fine, idled fine, then you could not seem to get the high end leaned out enough before they would start sagging, meaning that they were lean, but would be smoking a lot.  Found out it was a fuel problem, we had received a batch that did not have enough nitro content.  Replaced the fuel with good 30% and all of our engines started running perfect again.  There is an issue with the low end loading up and there is a fix for that if you are having that problem, but it sounds like your problem is on the high end.  As a reference, most of us are running a 16x11 APC prop and they turn approx 8800 static rpms.  We are only 14 feet above sea level, don't know where you are located at, but that would make a difference on rpm.  Anyway, would suggest a higher content nitro if you have some.  Larry
 
-----Original Message-----
From: bravo52 <bravo52 at cox-internet.com>
To: discussion at nsrca.org
Sent: Sun, 1 May 2005 22:44:54 -0500
Subject: YS 140 Help


O.K., 
    I've got a new 140 sport and it seems a little temperamental.  Just about every time I get to rotation speed, the thing sags and dies.  I've only run about a tank and a half on the ground so it is still "new".  It idles perfect and it starts on the first pop.  I'm not sure if it is loading up or going too lean.  I'm new to the 140.  Any advice would be helpful.
v/r
Jerry
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050503/bed1119c/attachment.html