[SPAM] Re: YS 110 help [PMX:]

[Pascale, Mike]

When you lap air box surfaces use 400 lapping compound and glass for a true
flat surface its alum. and will cut real easy
mike
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On
Behalf Of Jerry Stebbins
Sent: Thursday, March 24, 2005 8:20 AM
To: discussion at nsrca.org
Subject: [SPAM] Re: YS 110 help [PMX:]



Bob, there are no leak free gaskets that I know of for the 91. Best bet is
to carefully lap both surfaces, use a thin film of liquid gasket material,
and the YS gasket, then torque the screws so you do not bend the box ,
because it will deform over time. 
Jerry

----- Original Message ----- 
From: THERUPMAN at aol.com <mailto:THERUPMAN at aol.com>  
To: discussion at nsrca.org <mailto:discussion at nsrca.org>  
Sent: Tuesday, March 22, 2005 5:11 PM
Subject: YS 110 help

I need some YS help,please.
I've never had a 110 or a 91 before. Anyone out there found "Leak Free"
gaskets for it? About the only one that you need is for the air box, I
think. Are you 110 guys using the one piece gasket/diaphram or are you using
the tried and true ones that fit the rest of the YS"s?
I"ve seen the lists on the net with YS info. Just haven't read them all. 
Any help will be appreciated muchly. Or just point me to a forum and a post
that I've missed.
Thanks,
Bob Ruppel
Nashville,TN


The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you received
this in error, please contact the sender and delete the material from any
computer.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050324/c0f2b046/attachment.html