OS bearing removal

[Mike Hester]

Yup. Just heat it, then smack it against a piece of wood. It should fall 
out. I poke the front out with a 1/2" dowel, when I change it. But it rarely 
goes bad. I just do it occasionally for giggles.

-Mike

----- Original Message ----- 
From: "Jason" <jasonshulman at cox.net>
To: "NSRCA" <discussion at nsrca.org>
Sent: Tuesday, March 22, 2005 8:16 PM
Subject: OS bearing removal


> It's been a long time since I've changed bearings. Is the oven, at 350
> degrees, still the preferred method?
>
> Thanks,
> Jason
> www.jasonshulman.com
>
>
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.