YS valve not the only problem

Ken Thompson mrandmrst at comcast.net
Thu Jun 9 02:03:17 AKDT 2005


John,
Everything checks out except the crank movement.  The new bearings are being ordered today and I'm going to see Verne when I get them.
All should be well shortly.  
I am still in the market for a good YS-91AC if you know of anybody.

Ken
  ----- Original Message ----- 
  From: John Pavlick 
  To: discussion at nsrca.org 
  Sent: Thursday, June 09, 2005 12:41 AM
  Subject: RE: YS valve not the only problem


  Ken,
   Does it start Ok after it cools off? Make sure you set the valve lash correctly. You shouldn't have a lot of movement in the crank. That's another problem. At this point it is probably worth sending it in for service. Most of the guys I know that are flying YS have a backup motor - probably would be a good idea to find a second one. That way you can get the plane in the air while your motor is out for service. Before you send it in though, check the compression and the valve lash. You might find something there.
  John Pavlick
  http://www.idseng.com
    

    -----Original Message-----
    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On Behalf Of Ken Thompson
    Sent: Wednesday, June 08, 2005 9:05 PM
    To: discussion at nsrca.org
    Subject: YS valve not the only problem


    I just fired my YS-91 up after the valve cleaning.  It fired immediately and had plenty of power while still running rich.  After running for a minute or two the rpm's started fluctuating a bit.  The more it ran the less rpm's I was able to maintain.  I heard a noticable rattle that seemed to be coming from the engine area.  After the engine ran for about 5 minutes, the rpm's started to drop more.  I leaned the needle a little and the revs didn't increase, so I richened it back up and idled down, the motor died.  I felt the spinner to see if it was warm and it wasn't, that's when I noticed the movement of the output shaft.  My first thought is the front bearing, I have quite a bit of movement up and down and a little side to side.

    I guess I'm not meant to fly this plane.  Does anybody know where I can get a good YS-91, cheap?

    I think this one is going back to YS.

    Ken
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050609/2850a8f1/attachment.html


More information about the NSRCA-discussion mailing list