Screwing Belly Pans

[Tim Taylor]

Any way to cut the belly pan in two at the front of the wing and keep the front half on the fuse all the time and only remove the part over the wing?
  ----- Original Message ----- 
  From: Bob Pastorello 
  To: NSRCA 
  Sent: Saturday, January 29, 2005 9:41 AM
  Subject: Screwing Belly Pans


  Allrighty- here's a question for the creative types... My new Icepoint, truly a VERY high quality PARF, has the one piece wing (big, straight, light, well-covered), and it is covered with a REALLY long one-piece belly-pan/chin cowl that goes from the spinner face to the wing t.e.
      It is supposed to be held on with ten, 2mm screws....Since the wing/pipe has to come off every flying session, that's a LOT of screwing around with...

  ANYONE have any ideas for alternates?  Have considered the BVM 'canopy hooks', but not enough surface to grab everything properly.  I have about a 1/4" tall lip to hold onto from the pan.

  Please - no "That's why you buy plug-in wings, Bob" answers....

  Bob Pastorello
  NSRCA 199  AMA 46373
  rcaerobob at cox.net
  www.rcaerobats.net


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050129/0e2a0bd5/attachment.html