PBG carbon wing tube for IMPACT

[Atwood, Mark]

Do you know if these tubes will also work with the Rev Pro?  The tube I
have is SO tight you'd think you were going to break the wings getting
them on and off.  I've sanded the crap out of the tube and the sleeves
and it's better...but still way too tight.

The Rev Pro tube is already carbon...just wondering if these have better
tolerances.

-mark

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Wayne Galligan
Sent: Monday, February 28, 2005 11:32 AM
To: discussion at nsrca.org
Subject: Re: PBG carbon wing tube for IMPACT

Peter,

I just changed mine to a c.f. tube this winter and the phenolic tube in
the
fuse was a bit loose.  I used regular scotch tape (tip from Lance V.)
and it
worked perfect.  Add a layer or two to get the fit needed.  I was even
able
to shim the tube just a scootch to get the wing in perfect alignment
with
the tail feathers.  Lance claims it will not wear over time also.   A
lot
easier then gluing and sanding.

Wayne Galligan

----- Original Message ----- 
From: "Peter Pennisi" <pentagon.systems at bigpond.com>
To: <discussion at nsrca.org>
Sent: Monday, February 28, 2005 4:31 AM
Subject: PBG carbon wing tube for IMPACT


>
>
> Hi All,
>
> I have a PBG 30mm carbon tube for my IMPACT which is 35 grams lighter
than
> the original. Unfortunately it is a little loose in the existing wing
> sockets. What is a good technique to fix this? I don't want to add
anything
> to the tube itself otherwise I won't be able to use the carbon sleeve
> supplied.
>
>
> Regards,
>
> Peter
>
>
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to
http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.