PBG carbon wing tube for IMPACT

[Wayne Galligan]

Peter,

I just changed mine to a c.f. tube this winter and the phenolic tube in the
fuse was a bit loose.  I used regular scotch tape (tip from Lance V.) and it
worked perfect.  Add a layer or two to get the fit needed.  I was even able
to shim the tube just a scootch to get the wing in perfect alignment with
the tail feathers.  Lance claims it will not wear over time also.   A lot
easier then gluing and sanding.

Wayne Galligan

----- Original Message ----- 
From: "Peter Pennisi" <pentagon.systems at bigpond.com>
To: <discussion at nsrca.org>
Sent: Monday, February 28, 2005 4:31 AM
Subject: PBG carbon wing tube for IMPACT


>
>
> Hi All,
>
> I have a PBG 30mm carbon tube for my IMPACT which is 35 grams lighter than
> the original. Unfortunately it is a little loose in the existing wing
> sockets. What is a good technique to fix this? I don't want to add
anything
> to the tube itself otherwise I won't be able to use the carbon sleeve
> supplied.
>
>
> Regards,
>
> Peter
>
>
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.