Polyurethane Glue Solvent

[Bob Pastorello]

Yeah, Bob, a soft-flame torch would remove the glue.

Bob Pastorello
NSRCA 199  AMA 46373
rcaerobob at cox.net
www.rcaerobats.net


  ----- Original Message ----- 
  From: Bob Richards 
  To: discussion at nsrca.org 
  Sent: Saturday, February 19, 2005 7:21 PM
  Subject: RE: Polyurethane Glue Solvent


  I wonder if a heat gun might soften it enough to peel it off.

  spbyrum <spbyrum at hiwaay.net> wrote: 
    The instructions say acetone to clean up while it's wet and 80 Grit
    after drying. Bummer on the monocote.

    Steve Byrum 

    -----Original Message-----
    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
    On Behalf Of Ron Van Putte
    Sent: Saturday, February 19, 2005 1:08 PM
    To: discussion at nsrca.org
    Subject: Polyurethane Glue Solvent

    Does anyone know of a good solvent (gets the job done, but doesn't 
    dissolve the surface it's on) for dried polyurethane glue? I 
    accidentally spilled Gorilla Glue on a MonoKoted wing and didn't 
    discover it until the glue had dried. I've tried several solvents 
    without success. Help!

    Ron Van Putte

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20050220/209035e8/attachment.html