[NSRCA-discussion] Wing Tube

[William C. Harden]

Chuck, 

Don't take off too much because the tube will loosen after flying a bit.
The vibration from the engine will cause the tube and socket to wear.

Bill 

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Chuck
Hochhalter
Sent: Friday, December 23, 2005 1:30 PM
To: 'NSRCA Mailing List'
Subject: RE: [NSRCA-discussion] Wing Tube

After much digging, I found an old header ext and used the sticky sand
paper.. worked well...i will sand more later but much easier already..
thanks.

Chuck

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Verne
Koester
Sent: Friday, December 23, 2005 11:19 AM
To: NSRCA Mailing List
Subject: Re: [NSRCA-discussion] Wing Tube

Find a dowel that's smaller than the wing tube, wrap some sticky-back 
sandpaper around it, and sand the socket.

Verne

----- Original Message ----- 
From: "Chuck Hochhalter" <chochhalter at direcway.com>
To: "'NSRCA Mailing List'" <nsrca-discussion at lists.nsrca.org>
Sent: Friday, December 23, 2005 11:33 AM
Subject: [NSRCA-discussion] Wing Tube


>
>
> Just installed a wing tube and it is really tight.  Best way to make
it
> easier to slide in and out of the fuse??
>
> Thanks
>
> Chuck
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> 

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion