[NSRCA-discussion] securing servo wires

[Karl G. Mueller]

Dean,

That is exactly what I use to hold all my connectors together, extensions as
well.
Just a bit of a pain if you have to undo one. But cheap and light. A roll of
fishing
line lasts a lifetime.

Karl G. Mueller
kgamueller at rogers.com

----- Original Message ----- 
From: "Dean Pappas" <d.pappas at kodeos.com>
To: "NSRCA Mailing List" <nsrca-discussion at lists.nsrca.org>
Sent: Thursday, December 15, 2005 10:50 AM
Subject: RE: [NSRCA-discussion] securing servo wires


> Hi Guys.
> How about a nylon fishhing line loop that passes through all the
connectors, between two of the wires in the connector, and around the RX?
> I've never done anything like this, but now that I think of it, I like the
idea.
>
> Dean
>
> Dean Pappas
> Sr. Design Engineer
> Kodeos Communications
> 111 Corporate Blvd.
> South Plainfield, N.J. 07080
> (908) 222-7817 phone
> (908) 222-2392 fax
> d.pappas at kodeos.com
>
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Ken
> Thompson
> Sent: Thursday, December 15, 2005 5:56 AM
> To: NSRCA Mailing List
> Subject: Re: [NSRCA-discussion] securing servo wires
>
>
> David,
>
> I usually fold the wires down over the top of my receiver and secure them
> with a rubber band, around the receiver and wires, fairly snug.
> Make sure you leave enough wire so as not to bind the wire against the
> connector.
> Install as usual, sounds simple but it works for me.
>
> Ken
> ----- Original Message ----- 
> From: "David Flynt" <dflynt at verizon.net>
> To: <nsrca-discussion at lists.nsrca.org>
> Sent: Wednesday, December 14, 2005 10:51 PM
> Subject: [NSRCA-discussion] securing servo wires
>
>
> > Can anybody suggest a good way to help prevent servo wires from pulling
> > out
> > of a receiver?  I have never paid attention to this, and never really
had
> > a
> > problem except one time one of my elevator servo wires pulled loose.  I
> > was
> > fortunate to have half an elevator remaining and enough control to land.
> > But now I only use a single elevator servo.
> >
> > I typically use either JR r770 or r649 receivers.
> >
> > Any ideas would be appreciated.
> >
> > Thanks,
> >
> > David Flynt
> >
> > _______________________________________________
> > NSRCA-discussion mailing list
> > NSRCA-discussion at lists.nsrca.org
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion