paint/personal protection

[Amir Neshati]

I've sprayed this stuff outdoors on a calm morning or evening and the garage 
door wide open
while mixing....You may be a little safer using an HVLP since they don't 
blast out a ton of excess
over spray...I've used a charcoal mask and made sure I stood up wind of the 
stuff (the secret
to my behavior).....Since I found out the dangers of the stuff, ARFs look 
much more attractive.

Or, the safest method is to send it to Jerry to paint it for you ;-)

Amir

----- Original Message ----- 
From: "Jerry Budd" <jerry at buddengineering.com>
To: <discussion at nsrca.org>
Sent: Sunday, August 28, 2005 1:41 PM
Subject: Re: paint/personal protection


>
> Actually, if it's isocyanate based you should be using an "air 
> pressure-fed" respirator.  The charcoal won't be enough to filter the air 
> properly before you breathe it, you need a "clean" air supply.
>
> Jerry
> -- 
> ___________
> Jerry Budd
> Budd Engineering
> (661) 722-5669 Voice/Fax
> (661) 435-0358 Cell Phone
> mailto:jerry at buddengineering.com
> http://www.buddengineering.com
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
> List members email returned for mailbox full will be removed from the 
> list.
>
> 


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

List members email returned for mailbox full will be removed from the list.