Building Lasers

[Evan H. Dygert]

This discussion is getting a little too technical. 
Seriously though, being new to a lot of this, I would be 
interested in more details about how to use these laser 
thingys to check incidence. I am completely new to 
incidence checking so this probably sounds like a stupid 
request.

On Sat, 23 Oct 2004 18:37:53 -0500
  "Bob Pastorello" <rcaerobob at cox.net> wrote:
>Nope.  They're yellow, about 8" long, 3/4" thick, 2" 
>tall.  Has a bubble level included that has an LED for 
>use in dark, and the case has magnets built into the 
>base.  They were in the tool aisle right by the rest of 
>the laser thingys.
>
>Bob Pastorello
>rcaerobob at cox.net
>www.rcaerobats.net
>
>
>  ----- Original Message ----- 
>  From: Wayne Galligan 
>  To: discussion at nsrca.org 
>  Sent: Saturday, October 23, 2004 12:10 PM
>  Subject: Re: [SPAM] Re: Building Lasers
>
>
>  Bob,
>
>  Does this laser thingy have a couple of pins that push 
>out to like secure it to a wall?   I got one of these for 
>a gift and was wonderin if it was the same thingy or not. 
>  Mine is about 3" high x 4" long x 1" wide.  
>
>  WG
>
>    ----- Original Message ----- 
>    From: User211991 at aol.com 
>    To: discussion at nsrca.org 
>    Sent: Saturday, October 23, 2004 12:02 PM
>    Subject: [SPAM] Re: Building Lasers
>
>
>    Great idea Bob.. have a P/N or name on these gizmos ? 
>Where in Wally World were they located ?
>
>    Brian 

Evan H. Dygert
Dygert Consulting, Inc.
364 Twelve Oaks Dr.
Winter Springs, FL 32708
Tel: 407-739-8194
Email: evand at dygertconsulting.com
=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.