More Revolution Questions

[Rcmaster199 at aol.com]

The front rubber isolator. The design of the mount was first introduced by  
the Lord Corporation of PA I believe, hence the name

What is the front lord Mount??

----- Original Message ----- 
From:  _Rcmaster199 at aol.com_ (mailto:Rcmaster199 at aol.com)  
To: _discussion at nsrca.org_ (mailto:discussion at nsrca.org)  
Sent: Thursday, October 14, 2004 8:10  PM
Subject: Re: More Revolution  Questions



Dan, If your Rev Pro came with fiberglass beams you can use it as is,  except 
change the front lord mounts to the larger size. Mc master Carr  carries the 
one size larger you will need. Also you will need to epoxy the  mounting bolts 
into the beams. If yours has the aluminum beams as mine does,  it is much 
easier. To be safe, I added an additional nose ring to mine  vertically as my 
friend Gary did with his. Gary runs a 140 L and I run the  webra 160. No 
problems. The Hyde mount is not necessary.
 
The stock phenolic horns are fine but use the MK ball bearing clevises.  Gary 
mounted two servos in the tail for elevator control and I went with the  Nat 
Penton method of twin carbon push rods. For those of you that don't know  it, 
this was a Nat idea from about 25 years ago. 
 
For aileron servos, both Gary and I made cut outs in the panels,  installed 
ply mounts and installed the servos as we do any other  aileron servo in any 
other wing: output shaft and servo wheel just above the  skin.
 
good luck
 
MattK





 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20041015/9b2385dd/attachment.html