More Revolution Questions

[Atwood, Mark]

1. Ditto  (will send photos upon my return to town)
2. There is a section near where the control horn is put in that has an epoxy/micro ballon filling.  I drilled through that...haven't had a problem in 2 seasons.
3. Ditto...cut hatches.  You'll be surprised....and scared...how easily an x-acto knike will go through the wing skin.  It's like cutting paper...or more easily.   I also opened up the servo box a little so the servo would sit closer to the surface of the wing.
 
 

________________________________

From: discussion-request at nsrca.org on behalf of Tony Quist
Sent: Thu 10/14/2004 9:44 PM
To: discussion at nsrca.org
Subject: RE: More Revolution Questions


1.	I went with a hyde ar mount and a nose ring attached to the front. 
2.	I used the stock arms. It has not flown but it is a tight linkage I used Troy Newman's elevator linkage setup. 
3.	I just cut a hatch 
 
 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On Behalf Of Daniel J. Hamlett
Sent: Thursday, October 14, 2004 6:30 PM
To: discussion at nsrca.org
Subject: More Revolution Questions
 
I have just recently purchased a Revolution Pro. I have not started the assembly yet, I have a few questions that I want to get the answers to before I start. I am hoping that someone will read this that has one or knows somebody who does. 

1st. The model comes with an engine mount already installed. It says that it is a soft mount and is designed for a 140 2c or 4c. I am kind of unsure of the way the mount looks. I am going to be using a YS140 Sport. I have seen them run at idle and they can really shake. I was thinking of using a Hyde ARIS mount. Has anyone mounted one of these on this plane before. It is a composite air frame and didn't know how well it would work. 

2nd. The model comes with control horns <http://www.rcuniverse.com/buynow/keywordclick.cfm?bid_id=1174>  already installed ( composite arms ) I want to use MK horns & clevises. I know that I can cut off the horns that are on there now, the directions say that you can do this. I didn't see or missed where it said that it was ok to drill a hole in the control surfaces to put the horns in. I am concerned that there might not be a hard mount in the wing to mount the horn to. I don't want to cut off the originals until I get an answer on this. 

3rd. If you have put together an impact or Revolution then you know where the servos are mounted in the wings. For those who haven't seen it yet I will try to describe it as close as I can. The servos is mounted on it's side with the arm protruding out from behind or inside the skin on the wing. They are mounted in the 3rd or 4th wing spar in, about 12 or so inches from the wing root. HOW THE HELL DO YOU GET THEM IN THERE??????? I think that I have figured out how to put in the screws <http://www.rcuniverse.com/buynow/keywordclick.cfm?bid_id=1138>  but how do you put the servo in its place?? This one has me racking my brain. 

I am sure that I will come up with a ton more questions but that is all that I can think of right now. Any help on this would really be appreciated. 

Thank you for all the help. 
Dan 
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/ms-tnef
Size: 7274 bytes
Desc: not available
Url : http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20041014/28fc1efe/attachment.bin