Elev. Pull pull Question

[Bob Pastorello]

I think that was it.  As many of these as I've done, I guess I never ran into that....appreciate it!

Bob Pastorello
NSRCA 199  AMA 46373
rcaerobob at cox.net
www.rcaerobats.net


  ----- Original Message ----- 
  From: Jim Ivey 
  To: discussion at nsrca.org 
  Sent: Friday, November 26, 2004 8:40 AM
  Subject: Re: Re: Elev. Pull pull Question


  Bob
  Bend the screw and recheck.
  > Jim Ivey
  > From: "Bob Pastorello" <rcaerobob at cox.net>
  > Date: 2004/11/26 Fri AM 09:38:22 EST
  > To: <discussion at nsrca.org>
  > Subject: Re: Elev. Pull pull Question
  > 
  > Yep.  Same distance OUT from surface.  However, just checking things - again - the elevator that is travelling too far also has the control takeoff about 1/16" further FORWARD relative to the hinge line than the other half.
  >     Could this do it?
  > 
  > Bob Pastorello
  > NSRCA 199  AMA 46373
  > rcaerobob at cox.net
  > www.rcaerobats.net
  > 
  > 
  >   ----- Original Message ----- 
  >   From: Tom Hinton 
  >   To: discussion at nsrca.org 
  >   Sent: Friday, November 26, 2004 8:07 AM
  >   Subject: Re: Elev. Pull pull Question
  > 
  > 
  >   Are both the horns on the bottom the same distance from the surface, same amount of threads?
  >     ----- Original Message ----- 
  >     From: Bob Pastorello 
  >     To: NSRCA 
  >     Sent: Friday, November 26, 2004 8:58 AM
  >     Subject: Elev. Pull pull Question
  > 
  > 
  >     May seem obvious, but I could use some help here....setting up my Excelleron, centers are okay, cable tensions are pretty close, centering is good.  Up elevator is fine, on Down elevator, ONE elevator moves farther, but they track together except at the endpoint, as close as I can tell.
  > 
  >     Anyone have suggestions on how I'd fine tune this out...??
  >     Hope everyone had a great T-day!!
  > 
  >     Bob Pastorello
  >     NSRCA 199  AMA 46373
  >     rcaerobob at cox.net
  >     www.rcaerobats.net
  > 
  > 
  > 

  =================================================
  To access the email archives for this list, go to
  http://lists.f3a.us/pipermail/nsrca-discussion/
  To be removed from this list, go to http://www.nsrca.org/discussionA.htm
  and follow the instructions.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20041126/5cc951c2/attachment.html