Surface

[Wayne Galligan]

Tom,

Email me a photo of your press.

Thanks

Wayne
wgalligan at cnbcom.net

  ----- Original Message ----- 
  From: Tom Hinton 
  To: discussion at nsrca.org 
  Sent: Friday, November 19, 2004 5:23 PM
  Subject: Re: Surface


  MDF with 16 ga. u channels screwed to it is about as flat as anything I have found. I made a wing skin press out of two pieces and it is flat in any direction you put the straitedge on it. I was trying to put up a pic but it is too big.
  Tom
    ----- Original Message ----- 
    From: Jeff Hughes 
    To: discussion at nsrca.org 
    Sent: Friday, November 19, 2004 4:56 PM
    Subject: Re: Surface


    My slate is still on the table. I sheet all my wings and set up my planes on our pool table. It's an old bar table, probably weighs 1,000lbs assembled. I know you can't grab an end and move it. Most large cities have someone who sells top line pool tables, they will have excess slate.


      ----- Original Message ----- 
      From: Nat Penton 
      To: discussion at nsrca.org 
      Sent: Friday, November 19, 2004 2:34 PM
      Subject: Surface


      Mark where do you find the slate? Does it have to come from a table mfg ?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20041119/2e41bffd/attachment.html