Webra 1.45

[Joe Dunnaway]

Try a short piece of Tygon tubing slipped over the needle. (you may have to heat it up to get it over the needle) A small piece of yellow nyrod will slip in the other end and you can use a 2-56 screw or whatever you want in the nyrod.

Joe

  ----- Original Message ----- 
  From: David Wartel 
  To: discussion at nsrca.org 
  Sent: Tuesday, June 22, 2004 10:12 PM
  Subject: Webra 1.45


  Is there a replacemnet needle valve available for this engine that has a provision for an extension? The stem is short and only has a slot for adjusting with a screwdriver. Being so close the the prop, this is a little hazardous with a cowled engine.

  Alternatively, is there a simple way to add an extension to the needle?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040628/98ef4577/attachment.html