Webra 1.45

[Del Rykert]

How about brazing the cutoff head of allen bolt to head of needle then adjust with ball driver which allows more prop clearance if you don't want to go with remote needle.
 
    del

  ----- Original Message ----- 
  From: David Wartel 
  To: discussion at nsrca.org 
  Sent: Tuesday, June 22, 2004 11:12 PM
  Subject: Webra 1.45


  Is there a replacemnet needle valve available for this engine that has a provision for an extension? The stem is short and only has a slot for adjusting with a screwdriver. Being so close the the prop, this is a little hazardous with a cowled engine.

  Alternatively, is there a simple way to add an extension to the needle?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040628/d1095fbf/attachment.html