CA

Bob Kane getterflash at yahoo.com
Wed Jun 9 06:02:19 AKDT 2004


Yes, put the higes in and install the movable surface to the fixed surface before gluing. If you try to do one side at a time, say put the hinges in the elevator and glue them, then install the elevator to the horizontal stab, the CA will seal the porous surface material of the hinge and it will not wick properly.
 
I forgot to mention, use foam safe CA if you are working with foam core parts. You can use a pin in the center of the hinge to keep it centered while pushing it into the mating surface. Draw a line on the center of the hinge so you can verify it is centered before gluing. Take the pin out before you put the CA on. 

tph1 at bellsouth.net wrote:
Do you dry install both sides and then glue? Aileron and wing, elevator and stab etc.?
> 
> From: Bob Kane 
> Date: 2004/06/09 Wed AM 08:07:38 EDT
> To: discussion at nsrca.org
> Subject: Re: CA
> 
> Thin. Dry install all the hinges for a particular surface in the slots and make sure they are centered. Bend the surface one way, and put a couple of drops of thin CA in the center of each hinge. The glue should wet out the surface, add thin CA until it stops wicking into the material. Use a tissue or swab to clean any excess CA. Do the same side of all hinges. Clean any CA off the parts, turn over, and repeat on the other side of the hinges. 
> 
> Do not go back and add glue "just to be safe". Once the CA sets, any additional glue will not wick into the surface of the hinge and can create a sharp ridge in the center of the which will lead to failure over time.
> 
> I have never had a hinge fail using this technique. 
> 
> Tom Hinton wrote:
> What type CA for Radio South hinges, thick, medium or thin?
> thanks, Tom
> 
> 
> Bob Kane
> getterflash at yahoo.com
> 
> ---------------------------------
> Do you Yahoo!?
> Friends. Fun. Try the all-new Yahoo! Messenger
> 

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.


Bob Kane
getterflash at yahoo.com
		
---------------------------------
Do you Yahoo!?
Friends.  Fun. Try the all-new Yahoo! Messenger
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040609/56da380a/attachment.html


More information about the NSRCA-discussion mailing list