Masters 2005 Sequence > Quarter Half Quarter Roll

[Atwood, Mark]

Hey Brian,
 
This is a manuever that use to be in the sequence back in the late 90's...a nice manuever actually.  Basically, it's a 4 point, without a hesitation at inverted.  Roll rates should be consistent, hesitations on both knifes should be equal, and center is the middle of inverted.   Looks very pretty is executed well.
 
-Mark
 
PS...I seem to remember a lot of 5's being given out back then when both the 4pt and the 1/4-1/2-1/4 where in the same sequence.  A LOT of people flew the wrong manuever.
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On Behalf Of Brian Young
Sent: Thursday, July 29, 2004 12:00 PM
To: discussion at nsrca.org
Subject: Re: Masters 2005 Sequence > Quarter Half Quarter Roll


Im not finding a description of the Quarter, half, Quarter roll
 
So, im guessing its done just as it reads. Can anyone confirm.

Steven maxwell <patternrules at sbcglobal.net> wrote:

Here is the new 2005 schedule and detailed descriptions of the new maneuvers. 

1. Take-off (U) K=1 
2. Stall Turn, 1 and 1/4 Rolls up, 3/4 Roll down, Exit Inverted (U) K=4 
3. Half Outside loop, 2/4 roll on exit K=2 
4. Reverse Avalanche from top with 1 positive Snap at Bottom (D) K=4 
5. 1/2 loop with full Roll out K=2 
6. 45 degree Pyramid Loop with Half Rolls on up and down legs (U) K=3 
7. Humpty Bump, push or pull on top, 1/4 Roll Up, 3/4 Roll down K=3 
8. Quarter, half, quarter Roll (D) K=4 
9. Half Inside Loop, 2/4 roll on exit K=2 
10. Vertical Square-Eight from the Middle, Pilot's Option (U) K=4 
11. Mid-entry Figure Nine - pull 3/4 loop first, 1/2 roll down K=3 
12. Slow Roll (D) K=3 
13. Humpty Bump with Pilot's Option K=2 
14. Square Loop with 2/4 point rolls on all sides. First 2/4 on up-line (U) K=5 
15. Stall Turn with 1/2 Rolls K=2 
16. Inside-Outside Diamond Eight with 1/1, Full Rolls, on center 45's (D) K=5 
17. Immelmann Turn K=1 
18. 45 Degree Down, one positive Snap Roll (U) K=3 
19. Top  <http://www.rcuniverse.com/buynow/keywordclick.cfm?bid_id=705> Hat with 3/4 Roll Up, 1/4 Roll Down, Exit Upright K=3 
20. Reverse Knife-Edge (D) K=4 
21. Half Square Loop with 1/2 Roll Up K=2 
22. Two and a half Turn Spin, with 1/2 Roll on horizontal exit line (U) K=4 
23. Landing (U) K=1. 
Total K-Factor = 66 

Descriptions of new maneuvers for the 2005 season 

Stall Turn 1 and 1/4 Rolls up, 3/4 Roll down, Exit Inverted - Model pulls through one-quarter (1/4) loop to vertical flight, pauses, performs one-and-one-quarter (1-1/4) rolls, pauses, performs a 180 degree stall turn in the direction of the maneuver to a vertical dive, pauses, performs a three-quarter (3/4) roll in opposite rotation, pauses, then pushes through one-quarter (1/4) loop to recover in inverted level flight. 

Half Outside loop, 2/4 on exit - Model pushes from inverted level flight and executes half (1/2) out-side loop, immediately followed by 2 of 4 point roll, 
and finishes flying straight and level exactly 180 degrees from heading at entry. 

Reverse Avalanche with 1 positive Snap at Bottom - Model pulls down into a loop. At the bottom it executes one positive snap roll, recovers to complete the loop and finishes at top to level inverted flight. 

45 degree Pyramid Loop with Half Rolls up and down- Model passes through center and pulls 135 degrees, climbs, hesitates, executes one-half (1/2) roll, hesitates, then pushes through 90 degree loop, hesitates then executes one-half (1/2) roll, hesitates, then pulls through 135 degrees to level flight. 

Vertical Square Eight from the Middle, Pilot's Option - Model passes through center and pulls or pushes to commence a square loop, When first square loop is complete the model passes through center again and performs a second square loop exactly below or above, opposite to the first loop. 

Mid-entry Figure Nine - pull 3/4 loop first, 1/2 roll down - Model pulls 3/4 loop, hesitates, performs 1/2 roll on down-line, hesitates Pulls 1/4 loop. (Note loop entry point does not have to dissect down line) 

Square Loop with 2/4 point rolls on all sides. First 2/4 on up-line - 
Model passes through center and pulls through one-quarter (1/4) loop and executes square loop with corner segments of equal radius. In each leg, model hesitates, performs a 2 of 4 point roll, hesitates again before performing the next loop segment. 

Inside-Outside Diamond Eight with 1/1, Full Rolls, on center 45's 
Model passes through center and pulls one eighth (1/8) loop to 
45 degree up line, draws another straight line then pulls quarter (1/4) 
loop, draws straight line and pulls one quarter loop (1/4). Model hesitates 
and performs one roll (1/1), hesitates and pushes one quarter loop (1/4) to 
45 degree up line, draws line and then pushes one quarter loop (1/4), draws 
straight line, pushes one quarter loop (1/4), hesitates and performs one 
roll (1/1), hesitates pulls one-eighth loop (1/8) to level flight. 

I expect that #4, the Reverse Avalanche, might initially catch the attention of the Masters pilots. It has the snap at the bottom of the loop. When you look closer you will see that the maneuver is designed so that your plane will be almost level and upright just before for the snap component. The snap will be a single snap and will also be performed into the wind. All of these design decisions were calculated to make the maneuver more executable. 

Also I think that it actually should be called an inverted avalanche? 

 



Brian Young <b.young8070 at sbcglobal.net> wrote: 

Does someone have a handy copy of the 2005 masters sequence.

Thanks

Brian

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040729/379b8122/attachment.html