JR 8411 Gear Conversion

[wgalligan]

Bob, 
 
So far so good on the ones I have converted.  I now have about twice as
much time on these servos converted to SA’s as I did the original metal
gears and they are still relatively slop free and smooth.
But then I am not banging them up as hard as youse guys in Masters.  ;-)
 
Wayne G.
 
 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Bob Pastorello
Sent: Sunday, July 25, 2004 9:03 PM
To: NSRCA
Subject: JR 8411 Gear Conversion
 
Today, I did the conversion of a metal-gear 8411 to the SA
version....only left the metal OUTPUT gear in place, replacing all the
others.  It sure seems smooth, slop-free, tight, and powerful.
    I think I heard about this (leaving the metal output gear installed)
from Troy Newman....or someone else I can't recall...
 
Question - does this work over the long haul?  Any downside effects of
leaving the output metal?
Appreciate any experience here.

Bob Pastorello
rcaerobob at cox.net
www.rcaerobats.net
 
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040725/78bbf1be/attachment.html