Webra 1.45 problem

[Bob Pastorello]

Webra 1.45 problemMake sure your clunk inside the tank isn't tangling up on the vent line, or touching the back of the tank, OR that there's a hole in the fuel pickup line where it goes on the tube in the stopper.....any of those would cause a time-into-flight failure...

Bob Pastorello
rcaerobob at cox.net
www.rcaerobats.net


  ----- Original Message ----- 
  From: Gordon Anderson 
  To: discussion at nsrca.org 
  Sent: Saturday, July 24, 2004 3:37 PM
  Subject: Webra 1.45 problem


  I'm having a problem with my Webra 1.45 and I hope someone can help me out. I have a new Hydeout (thanks to the guys that gave me the control throw advice!)  with a new Webra 1.45. Below are the details on the motor setup:

  Prop: APC 17x2 
  Fuel: Magnum #1 
  Plug: OS #8 
  Pipe: Greves 
  Mount: Hyde type soft mount and nose ring 
  Tank: Tetra 20oz, on CG of model 
  I have about 2/3 of a gallon of fuel run through the motor, this Webra uses the regular carb with the high speed and low speed needles.

  The problem is the motor dies when I roll from inverted to upright. This happens mostly after I have been at idle for a while. I'm flying the advanced routine and it dies during the roll out on the bunt and the bottom of the double I even the slow roll. I have never made it more than about 3 minutes into a flight.

  It seems to run fine on the down lines at idle, like in the stall turns and the outside square loop. 
  When it dies it sounds like someone pulled the fuel line off the engine, it just un winds. We tried leaning the low speed needle, replaced the tank internal fuel line to the clunk.

  Any advice? 

  --Gordon 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040724/f272eaf2/attachment.html