Removing crankshaft on YS140L

[john tarpinian]

thanks Terry,

After I sent off the email I thought about it again
and finally worked the assy loose.  The old gasket was
really holding the disc valve assy in place.

Thanks again,
John

--- Terry Brox <tbrox at cox.net> wrote:
> You do not need to remove the disc valve screw. Just
> remove the rear
> cover/disc valve assembly. The crank pin sets in a
> recess hole in the disc
> valve. Nothing holds the disc to the Crank. Be sure
> to remove the camshaft
> before removing the crank. Good luck, Terry
> ----- Original Message ----- 
> From: "john tarpinian" <jtarpinian at yahoo.com>
> To: <discussion at nsrca.org>
> Sent: Friday, July 16, 2004 9:36 PM
> Subject: Removing crankshaft on YS140L
> 
> 
> > I'm trying to remove the crankshaft on a YS140L in
> > order to inspect the rear bearing.  I'm having
> trouble
> > removing the disc retainer screw which holds the
> disc
> > valve assy to the crankshaft.  When I try to turn
> the
> > screw it creaks and feels like it's going to snap.
> > Any help would be appreciated.
> >
> > Thanks
> > John Tarpinian
> >
> >
> >
> > __________________________________
> > Do you Yahoo!?
> > Vote for the stars of Yahoo!'s next ad campaign!
> >
>
http://advision.webevents.yahoo.com/yahoo/votelifeengine/
> >
> > =====================================
> > # To be removed from this list, go to
> http://www.nsrca.org/discussionA.htm
> > and follow the instructions.
> >
> 
> 
> =====================================
> # To be removed from this list, go to
> http://www.nsrca.org/discussionA.htm
> and follow the instructions.
> 
> 



		
__________________________________
Do you Yahoo!?
Vote for the stars of Yahoo!'s next ad campaign!
http://advision.webevents.yahoo.com/yahoo/votelifeengine/

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.