YS 140 FZ to L Conversion Help Needed

[Don Ramsey]

Replace the o-rings in the intake manifold (intake pipe) part # 71 on http://www.centralhobbies.com/Engines/parts/YS140LEX.htm or seal the top and bottom of that part with silicon.  If this doesn't work replace other o-rings.

Don
  ----- Original Message ----- 
  From: Bob Kane 
  To: discussion at nsrca.org 
  Sent: Sunday, July 11, 2004 10:24 AM
  Subject: Re: YS 140 FZ to L Conversion Help Needed


  Hmmmm . . . . . .  you have put all the right parts in and assuming the rest of the engine is sound. . . . .   my guess is an air leak. The low end needle on my conversions is usually about 3/4 turn out from closed. Did you replace the gaskets?

  Ed White <edvwhite at yahoo.com> wrote: 
    Folks,

    I need some advice. I've converted my YS 140 FZ to an
    L. New crank, crank ring, L throttle barrel and new
    throttle barrel seal. Great increase in power, but
    can't get it to idle worth a damn. I either fly with
    a very high idle or it quits in the air after its been
    at idle. On the ground I have to either set a very
    high idle (>3000 rpm) or it just looses rpm until it
    dies. In the air if it doesn't have the very high
    idle it quits after any maneuver that needs it to idle
    on a long downline. It continues to idle but quits
    when I increase throttle.

    Here are some of the particulars: OS F plug, Magnum 1
    and 1.5 fuel (acts the same with both fuels), 17-10N
    prop

    When this engine was an FZ it ran and idled
    beautifully in this same plane (same tank, same fuel
    lines, same throttle servo). Just was a little shy onpower for the Masters sequence.

    Things I've tried:

    low speed need settings from 1 to 2 turns (lots of
    settings in between)
    new glow plug
    removed the regulator ballast
    put in a new piston ring
    drilled holes in the piston
    new diaphragm

    None of the above made any difference I could tell. 
    Have torn it down far enough to replace the piston
    ring and reassembled. Found nothing out of place.

    Aside from buy another engine, I'd appreciate any
    suggestions.

    Thanks,

    Ed



    __________________________________
    Do you Yahoo!?
    New and Improved Yahoo! Mail - Send 10MB messages!
    http://promotions.yahoo.com/new_mail 
    =====================================
    # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
    and follow the instructions.




  Bob Kane
  getterflash at yahoo.com


------------------------------------------------------------------------------
  Do you Yahoo!?
  Take Yahoo! Mail with you! Get it on your mobile phone.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040711/c6ff8525/attachment.html