DuBro Servo Arms-JR Servos

[Ed Deaver]

Hey Bob.  Have used these up to 36% planes without problems.  Several things though.

1)  The throat of the spline is taller so it may appear as though they havent gone down all the way but have.

2)  Because of the tallness, a different set of screws would be needed.  You want screws(for non-metal gears) that are 1/8-1/4" longer as the output shaft can twist off as the screw is a part of the hardness/stiffness of the nylon output shafts.

Ed
  ----- Original Message ----- 
  From: Bob Pastorello 
  To: NSRCA 
  Sent: Saturday, November 29, 2003 9:30 AM
  Subject: DuBro Servo Arms-JR Servos


  Wondering if anyone has used these?  What's your experience on JR servos?
  I have a couple that seem to not be seating fully down on the output shaft no matter how tight.  Almost as if something is stopping the arm from going on all the way.

  Any thoughts, insights?

  Bob Pastorello, Oklahoma
  NSRCA 199, AMA 46373
  rcaerobob at cox.net
  www.rcaerobats.net

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040120/db36ca95/attachment.html