OS1.40 Pipe

[Henderson,Eric]

They are hard to bend without kinking. I usually cant the engine to the side to line up the header. 

If it is a MAC, one piece header - no exhaust stub and o-rings - it is advisable to cut the header half way up the header rise, and fit a second coupler. This will allow you to rotate the tubing and also provide protection from header fractures.

Regards,

Eric.

-----Original Message-----
From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]On Behalf Of Jeff Hughes
Sent: Sunday, February 29, 2004 7:28 PM
To: discussion at nsrca.org
Subject: OS1.40 Pipe


Now that I have my OS1.40 mounted in my new focus, I find that the pipe hits
the side of the pipe tunnel due to the right thrust. Can I just bend the
pipe, or should I heat it first?

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#

==================# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#