PPG basecoat clear coat question

[Tony Stillman]

Tony:
I have supplied basecoat before, so I'm not sure why Ben (my associate)
would have told you we didn't have it.  We do sell very little in
comparison...

Tony Stillman
Radio South
3702 N. Pace Blvd.
Pensacola, FL 32505
1-800-962-7802
www.radiosouthrc.com
----- Original Message ----- 
From: "Tony Quist" <quist23 at cox.net>
To: <discussion at nsrca.org>
Sent: Wednesday, February 25, 2004 9:05 AM
Subject: RE: PPG basecoat clear coat question


> Tony,
>
> When I ordered paint last week, I asked for basecoat but was told you
> only did concept.
>
> Tony Quist
>
> -----Original Message-----
> From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
> On Behalf Of Tony Stillman
> Sent: Wednesday, February 25, 2004 5:58 AM
> To: discussion at nsrca.org
> Subject: Re: PPG basecoat clear coat question
>
> Sir:
>
> No, I don't sell Ditzler, I sell PPG in basecoat.
>
> Tony Stillman
> Radio South
> 3702 N. Pace Blvd.
> Pensacola, FL 32505
> 1-800-962-7802
> www.radiosouthrc.com
> ----- Original Message ----- 
> From: "Jerry Budd" <jbudd at QNET.COM>
> To: <discussion at nsrca.org>
> Sent: Tuesday, February 24, 2004 9:16 PM
> Subject: Re: PPG basecoat clear coat question
>
>
> > Tony,
> >
> > Am I understanding you right, you also sell the Ditzler basecoat
> > (DBU) colors that match Monokote?
> >
> > Thx, Jerry
> >
> >
> > >Troy:
> > >
> > >Yes, the DCC is listed at 8 hours for the paint to cure to a point
> where
> you
> > >can mask on it.  I usually spray 2 colors in a day, but that would
> just
> > >about be the limit....
> > >
> > >Using the DBC will get the job done much quicker, but for the price
> of
> being
> > >more susceptible to fuel problems if the finish is scratched...
> > >
> > >Both systems have good points and bad!  I sell much more DCC stuff,
> but I
> do
> > >sell quite a bit of DBC as well....
> > >
> > >
> > >Tony Stillman
> > >Radio South
> > >3702 N. Pace Blvd.
> > >Pensacola, FL 32505
> > >1-800-962-7802
> > >www.radiosouthrc.com
> >
> > -- 
> > ___________
> > Jerry Budd
> > mailto:jbudd at qnet.com
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
> >
>
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>
>


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#