receiver antenna and wire placement

[Gray E Fowler]

I would imagine the problem would be wire chaffing...the fiberglass is 
very abrasive.



Gray Fowler
Principal Chemical Engineer
Composites Engineering




"PPandelaers" <ppandelaers at pandora.be>
Sent by: discussion-request at nsrca.org
02/23/2004 01:06 PM
Please respond to discussion

 
        To:     <discussion at nsrca.org>
        cc: 
        Subject:        RE: receiver antenna and wire placement


Can anyone explain why this is a problem? The antenna-wire is
plastic-covered.

;-)
Patrick


-----Oorspronkelijk bericht-----
Van: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
Namens ronlock at comcast.net
Verzonden: maandag 23 februari 2004 17:53
Aan: discussion at nsrca.org
Onderwerp: Re: receiver antenna and wire placement

Aong same idea, to keep battery and servo wires from
chafing against fiberglas and composite materials, 
you can line the fuse area with a sheet of paper.

later, Ron Lockhart
> It works fine.
> Take care that the exposed antenna wire cannot chafe against the fiber
glass
> fuse, the last pattern airplane I lost sufferred that!
> 
> John Ferrell
> http://DixieNC.US
> 
> ----- Original Message ----- 
> From: "JonAlan Wise" <wise at alaskalife.net>
> To: <discussion at nsrca.org>
> Sent: Monday, February 23, 2004 12:05 AM
> Subject: receiver antenna placement
> 
> 
> > Hi all, What is the best way to run the receiver antenna on a 
composite
> > fuse pattern plane? I am building a Temptation, I`m thinking of 
putting
> > the antenna in a tube inside the fuse. Will this work or will it 
create
> > radio reception problems? Any other ideas? Thanks Jon Wise
> > Anchorage, Alaska
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
> 
> 
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040223/8219fedf/attachment.html