Airtronics aluminum servo arms

[Anthony Romano]

A little thin Ca works to!


>From: "Henderson,Eric" <Eric.Henderson at gartner.com>
>Reply-To: discussion at nsrca.org
>To: <discussion at nsrca.org>
>Subject: RE: Airtronics aluminum servo arms
>Date: Mon, 9 Feb 2004 09:15:44 -0500
>
>A trick to tightening up the splines is to use aluminum foil around the 
>shaft.
>
>Some of the casting is poorly done. If the arm does not seat to the full 
>depth (compare with a "good" one), then I would trash the arm
>
>Regards,
>
>Eric.
>
>.
>-----Original Message-----
>From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On 
>Behalf Of Anthony Abdullah
>Sent: Monday, February 09, 2004 9:11 AM
>To: discussion at nsrca.org
>Subject: RE: Airtronics aluminum servo arms
>
>
>The JR aluminum arm fit to the metal output shaft Airtronics servo is very 
>good, but for some reason the fit to the plastic output gear is just a 
>little sloppy. It should be a relatively tight fit, but it will slide on 
>and off pretty easily.
>
>"Atwood, Mark" <atwoodm at paragon-inc.com> wrote:
>
>Hey Anthony,
>
>I'm afraid then that you wouldn't be pleased with the fit of the JR 
>Aluminum wheels on JR servo's either.  The splines are virtually identical 
>I beleive.  I've used both wheels interchangably for a while with good 
>success.  I don't think you'll find anyone making a dedicated wheel for 
>Airtronics...and if they did, they'd label it for Airtronics/JR 
>anyway...lol
>
>-Mark
>-----Original Message-----
>From: Anthony Abdullah [mailto:aabdu at sbcglobal.net]
>Sent: Monday, February 09, 2004 8:46 AM
>To: discussion at nsrca.org
>Subject: Airtronics aluminum servo arms
>
>
>
>Does anyone know of a source of aluminum servo arms made specifically for 
>Airtronics servos? The best I could find were the heavy duty plastic with 
>aluminum hub reinforcement, and an RC car set that is aluminum, but with 
>plastic inserts to fit different brands of servos.
>
>I have already called Central, Radio South, Tower, and Airtronics. I am not 
>pleased with the fit of the JR aluminum wheels to Airtronics.
>
>TIA
>
>Anthony
>

_________________________________________________________________
Get some great ideas here for your sweetheart on Valentine's Day - and 
beyond. http://special.msn.com/network/celebrateromance.armx

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#