Servos

[Nat Penton]

I'm confusing myself , Troy did not say replace only the servo output gear ( and motor gear ) with plastic as I ended up with on my second servo, he said just the opposite, leave motor and servo arm stock, and make the rest plastic. This servo sure did feel tight though.
  ----- Original Message ----- 
  From: Nat Penton 
  To: discussion at nsrca.org 
  Sent: Tuesday, February 03, 2004 9:28 PM
  Subject: Servos


  I had two DS9411's coverted to SA . A gear , or gears, stripped in both with relatively no torque by hand. They could have easily crashed an airplane. Does  the stock SA have all plastic gears, or only one or two ? These were converted to all plastic.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040204/d7062f1e/attachment.html