Webra Bearing Change

[Brian Young]

1.45 and 1.60 are the same bearings.

Emory Schroeter <emorydmd at earthlink.net> wrote:
Another bearing question for the Webra...

Are the bearings for the 1.45 and 1.60 the same? I called Boca the other day
and they only had the 1.45 listed. Anyway, he also said that they have the
front stainless bearings in stock, but are still waiting for the rear
bearing. He said it may be another 8 weeks.

Thanks, Emory Schroeter.

----- Original Message ----- 
From: "Jerry Budd" 
To: 
Sent: Sunday, August 01, 2004 9:07 PM
Subject: Re: Webra Bearing Change


> >OK-- while we are talking Webras, any secrets in changing the bearings.
> >
> >With over 20 gals through mine, I finally detected some movement.
> >I'm trying to get the connecting rod off the crank pin, but it gets
> >about 3/4 out and doesn't want to go further with "normal" force.
> >
> >Yes, the piston sleeve is out and the conn rod is slid as far to the
> >rear as it appears to go. You don't pull the piston wrist pin or
> >anything special like that?
> >
>
> Uh, yes you do.
>
> Remove the rear wrist pin retaining clip, clean away any carbon
> buildup from the aft wrist pin access hole in the piston, and then
> thread one of the head screws into the wrist pin. Grab the screw
> head with some pliers and pull - HARD. The key to this is lightly
> scrapping away any carbon buildup from the aft wrist pin hole on the
> piston (I use an X-Acto knife to do this).
>
> It's not like the OS where you can remove the rod from the crank pin
> without removing the wrist pin.
>
> Jerry
> -- 
> ___________
> Jerry Budd
> mailto:jbudd at qnet.com
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040801/9ec90846/attachment.html