OS 91 FX suitability

[Randy]

What pipe and header are you using?  I have an OS91FX.  It would be nice to see it work.
randy
  ----- Original Message ----- 
  From: Nat Penton 
  To: discussion at nsrca.org 
  Sent: Monday, April 19, 2004 9:19 PM
  Subject: Re: OS 91 FX suitability


  Stavros I have been running the 91FX about 3 years and am very fond of it. You will need to run the sealed bearings that are availiable from Boca Bearing. It is important that the crankcase get adequate cooling. I run a pipe length of 24" face of exh to baffle and use the following props :  14.5-11 4bl, 17-10N cut to 16", 30% nitro. You can easily handle up to 9#. You can get the  crankcase pump OS sells for the new heli engine.      Good luck         Nat Penton
    ----- Original Message ----- 
    From: Stavros Ioannidis 
    To: discussion at nsrca.org 
    Sent: Monday, April 19, 2004 6:55 AM
    Subject: Re: OS 91 FX suitability


    Thank you Matt K. and everyone else who answered to my letter.
    I am in Greece and since my last pattern plane is allready ten years old (Conquet IV)and a two meter plane is too much (and expensive) for our local competition (and F3A practicing), I choosed the Swallow with OS 91 FX but my concern is the bad rumors  that I heard about the OS 91 FX (needle valve assembly, ABN plating etc) and I wonder if a 4C is more suitable for my plane.

      ----- Original Message ----- 
      From: Rcmaster199 at aol.com 
      To: discussion at nsrca.org 
      Sent: Δευτέρα, 19 Απριλίου 2004 6:49 πμ
      Subject: Re: OS 91 FX suitability


      Yia sou Stavre. 

      The OS 91FX will work fine in this application. My friend Nat Penton uses the engine on his 8+ pound models, and also has adapted the Perry pump on the backplate. His pipe length is longish by many standards but it needs to be since he turns a 17x10N 2 blade or the small 4 blade apc props (13.5x11 4 blade)

      Are you in Greece or US?

      Matt K 





          ----- Original Message ----- 
          From: Stavros Ioannidis 
          To: NSRCA 
          Sent: Sunday, April 18, 2004 1:56 PM
          Subject: OS 91 FX suitability


          I want to haul a Swallow 90 for using it in aerobatics. Is the OS 91 FX a reliable engine or there is a better choice ? Any suggestions ? Thank you in advance.

          Stavros I.





-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040420/026b47f6/attachment.html