Trim Question

[Nat Penton]

Dan what about present mixes?
----- Original Message ----- 
From: "Dan Curtis" <warrior523 at mchsi.com>
To: "NSRCA Discussion" <discussion at nsrca.org>
Sent: Sunday, April 18, 2004 4:52 PM
Subject: Fw: Trim Question


>
> -----
> Subject: Re: Trim Question
>
>
> > Guys, thanks for the responses so far.  In my haste or forgetfullness I
> did
> > not mention that I had been trying the diffential thing with little to
no
> > help.  On axial rolls in tracks very well, doing the reverse cuban on
both
> > ends it holds line very well.  Bob P. , I have thought about the fact
that
> I
> > must be getting some elevator in the roll to knife or not getting off of
> it
> > soon enough and I can't rule that out except I am mode 1 and have done
the
> > roll to knife edge using aileron stick only just to observe it pulling
to
> > the canopy.  I am going to be moving the cg back some and see the
effect.
> > As for as differential goes, I am going to kind of start over on that
one
> > and set all deflections equal and move cg and start again.  The plane
does
> > have a counter balance on the rudder, Troy.  Aileron rolls to inverted
> don't
> > seem to be having a problem either, its when you do a slow aileron
> movement
> > to knife edge that it shows up.
> >
> >
> > Again thanks for the help so far it is appreciated.
> >
> > Dan
> >
> >
> >
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.