Side Mounting Servos

[Lance Van Nostrand]

Bob,
I do it this way too.  There is a metric sized screw, I think 2mm that fits
servos perfectly.  I found some matching nylon stop nuts at the h/w store to
back them up.
--Lance

----- Original Message ----- 
From: "Amir Neshati" <amirneshati at earthlink.net>
To: <discussion at nsrca.org>
Sent: Sunday, September 07, 2003 10:09 PM
Subject: Re: Side Mounting Servos


> Looks good to me too....A friend had a bunch of flights on his plane
(well,
> I flew most
> of them) with this servo mounting setup on the elevator. Might just
consider
> a piece of
> 1/8" ply backing where the servo screws are.....
>
> Amir
>
> > Looks good to me, Bob.
> > G.
> >
> > Bob Pastorello wrote:
> >
> > > Here's how I'm going to try doing my side-mount servos..comments would
> > > be appreciated.  Whatcha think?
> > > http://www.rcaerobats.net/SideMountServos.htm
> > >
> > >
> > > Bob Pastorello
> > > El Reno, OK
> > > AMA 46373, NSRCA199
> > >
> > >
> > > =====================================
> > > # To be removed from this list, send a message to
> > > # discussion-request at nsrca.org
> > > # and put leave discussion on the first line of the body.
> > > #
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#