bearing question
Wayne Galligan
wgalligan at goodsonacura.com
Wed Oct 22 05:48:18 AKDT 2003
Eric,
Is that on a 2 or 4 stoke engine? I haven't had any problem on my OS this way so far. Am I just lucky or is there a difference in bearings and the grease in them. I installed a bearing made by Bearings Limited distributed by Purvis out of Dallas. I know of several guys in this area that do it this way.
Wayne G
----- Original Message -----
From: Henderson,Eric
To: discussion at nsrca.org
Sent: Wednesday, October 22, 2003 8:36 AM
Subject: RE: bearing question
FYI - the grease will leak. If you are pressurizing from the crankcase it can make it to the tank and the fuel supply. The grease congeals just like snot (sorry but that was the best description available this AM) when mixed with methanol. Also it has reached the metering slot in the carb. more than once for me.
Regards,
Eric.
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On Behalf Of Wayne Galligan
Sent: Wednesday, October 22, 2003 8:22 AM
To: discussion at nsrca.org
Subject: Re: bearing question
Emory,
Some of us have been just leaving the seal and grease in the bearing. I had replaced the bearing on my OS and the first replacement bearing I removed the seal and rinsed the grease out of it and just used after run to lube it back up after the install. Well!!! this bearing only lasted about 20 flights. New bearing in now with seals in place has over 50 flights and doing fine.
Wayne G.
----- Original Message -----
From: Emory Schroeter
To: Pattern NSRCA
Sent: Tuesday, October 21, 2003 8:21 PM
Subject: bearing question
Hello,
I have some replacement bearings for my ST3250 that have the covers over the balls. I think they may also have some grease packed in there. How do I remove the cover to wash it out. Do I just pry it off? I don't want to mess up the bearing.
Thanks in advance.
Emory Schroeter
emorydmd at earthlink.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031022/d3589a59/attachment.html
More information about the NSRCA-discussion
mailing list