Rudder pull/pull

[Brian Young]

Clay, Ive had the same happen. You can put some drag
on the lines and it will dampen the oscillation. I
notice on my recent plane this isnt a problem, I think
because I ran the lines through some small diameter
plastic tubes to exit the fuse.

--- Terry Brox <tbrox at cox.net> wrote:
> Hi Clay,
>          Mine does the same thing on both Patriots.
> And cuz says his does the same as I am sure everyone
> else will attest to. Seems to go away when flying.
> Have a good evening, Terry
>   ----- Original Message ----- 
>   From: Clay Schmidt 
>   To: discussion at nsrca.org 
>   Sent: Saturday, November 29, 2003 9:46 PM
>   Subject: Rudder pull/pull
> 
> 
>   Hello all,
> 
>   I know this subject has been touched on before but
> I can't remember the solution, so I'm asking again. 
> 
> 
>   I'm setting up the rudder pull/pull in my new
> plane.  I'm using a 8411sa on the rudder. 
> Everything seems to be fine but I will get an
> occasional oscillation at neutral. It will stop when
> I touch the servo arm with my finger, but as soon as
> I wiggle the stick the oscillation will start again.
>  Any ideas?
> 
>   Thanks,
> 
>   Clay Schmidt


__________________________________
Do you Yahoo!?
Free Pop-Up Blocker - Get it now
http://companion.yahoo.com/
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#