Building & alignment Laser Level
BUDDYonRC at aol.com
BUDDYonRC at aol.com
Thu Nov 27 11:51:17 AKST 2003
Steve
Yes in fact you need to provide a permanent mount at the four corners of your
board.
So far I have not completed mine yet but the way that this should be done is
to make two mount's for each laser one for each corner of your table. you will
need a target at the opposite end of your table set at the center highth of
the beam that will allow you to level each laser and to confirm that the two
lasers are adjusted to exactly the same highth, this could be attached to the
permanent laser mount opposite the laser or could be located on the center line
on each end of your table between the two permanent mounts. The object is to
be able to set and zero level both units to the same reference point
elevation. and allow you to obtain repeatable adjustments should you move a unit from
one end to the other or remove it for storage or to change batteries etc.
I have taken the pictures but have not downloaded them yet, It may be next
week before I get time to do it but when I get it done I will notify you with a
post here.
Buddy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031127/62dc5b64/attachment.html
More information about the NSRCA-discussion
mailing list