CTE

[Amir Neshati]

Scared of the Kevlar or the Wayne?

Amir
  ----- 
  I hear ya, I hear ya, but I'm still scared. 
  G. 
  Wayne Galligan wrote: 

     Georgie I had kevlar pull/pull on my Prophecy for over two years with no incidence at all.  Don't be afraid....  kevlar is good!   Its so easy to use and if you every did need a field repair it is so easy to re rig.   Tie it off and a drop of c/a on the knot and go flying again. Wayne 
      ----- Original Message -----
      From: george kennie
      To: discussion at nsrca.org
      Sent: Tuesday, November 25, 2003 11:57 AM
      Subject: Re: CTE
       Sorry to disagree here, but it would appear that the conclusion being drawn by the respondants is that the pushrod expansion and contraction is the major cause of the problem. Not so, in my experience! Going to pull-pull cables, whether they be steel or kevlar thread will not get rid of the elevator trim change under consideration here.The coefficient of thermal expansion between the cables, which is very small, and the balsa in the fuse, which is significantly greater(glass too) will generate a differential of sufficient magnitude that the "devil" will still attack you when you least expect it. 
      The best solution that I have observed is to put the servos in the stabs. Short of this, I have been using servos mounted just at the L.E. of the stab and using a very short pushrod(approx. 6"). My current thinking is that I will still mount the servo in the same area and go with cables.Very light and direct. As regards Kevlar, I currently have a pattern practise ship that I do almost all of my flying with that has kevlar on the rudder and it has two years of mucho sequences to it's credit with no apparent wear or abrasions to the thread. At this point in time I have still not acquired the necessary intestinal fortitude to use kevlar on the elevator. 
      Georgie 
      Amir Neshati wrote: 

        Pull-pull will eliminate the trim change... Amir 
          ----- Original Message -----
          From: Nat Penton
          To: discussion at nsrca.org
          Sent: Monday, November 24, 2003 7:24 PM
          Subject: CTE
           Gray what is the CTI for balsa ? I have carbon push rods / balsa fuse and my elev trim moves around considerably. I suppose it is because of humidity variation between the shop and outdoors ?? The pushrods are 50" long.      NatPenton
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20031126/877a607b/attachment.html