Glassing wing center section

[Rick Wallace]

Jerry -- 
I assume you're glassing out at least an inch past where the fuse mates with
the wing? 
As long as the cloth is wetted and fully in contact with / bonded to the
wing surface you should be fine. More epoxy will just add weight, not
strength. Some lightweight filler should get things smoothed out. 
When I built my Elan and had to relieve the bottom of the wing for the
exhaust system, I glassed the resulting sanded-out indented bare foam area
also. 


Rick 

> -----Original Message-----
> From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
> On Behalf Of Jerry Wilson
> Sent: Monday, November 24, 2003 8:07 PM
> To: discussion at nsrca.org
> Subject: Glassing wing center section
> 
> I'm glassing the center section of my Elan.  Using 6 oz/yard K&B cloth
> and 30 minute epoxy warmed with a heat gun on application.  The epoxy
> brushes on well and when dry the weave of the cloth is noticeable.  In
> other words the surface is not a smooth glasslike finish.  Is this OK or
> do I need more epoxy applied for strength?
> 
> Thanks,
> Jerry Wilson
> Katy,TX
> NSRCA#3107
> AMA#119585
> 
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #

==================# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#