For Sale: JR 8417 servos NIB

[davel322 at comcast.net]

Ditto.

Been doing this for 3 years and averaging about 700 flights on an 8417(sa) before servicing.

Dave Lockhart (Team JR)
DaveL322 at comcast.net
> These are good servos for pattern models. I have been using them on the
> elevator....They are killer quick and help with crisp entry and exits from
> snaps. I have been converting mine with 8231 gears similar to an 8411SA
> convert....The gears are not a direct replacement you leave the plastic gear
> off the motor and leave the metal output gear alone very similar to the
> 8411SA convert..... and the servos speed of like 0.09sec slows a little
> maybe around 0.12-0.13 secs and the torque increases a little....I have been
> running this setup on Elevator now for 2 years of hard flying and they work
> great.
> 
> Pot wear is nothing is minimal too...Ailerons are the big servo pot
> eater....not the elevator but I have had really good pot life with the 8417
> converts. Just thought I would get these servos a plug I really like them.
> 
> 
> Troy
> ----- Original Message ----- 
> From: "Brian Young" <b4598070 at yahoo.com>
> To: <discussion at nsrca.org>
> Sent: Monday, November 10, 2003 3:18 PM
> Subject: For Sale: JR 8417 servos NIB

> 
> 
> > I have 3 new JR 8417 servos for sale. $85 each, you
> > pay shipping.
> >
> > Brian Young
> > Tulsa
> > 918-838-0900 work
> > nsrca 2417
> >
> > __________________________________
> > Do you Yahoo!?
> > Protect your identity with Yahoo! Mail AddressGuard
> > http://antispam.yahoo.com/whatsnewfree
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#