switch failure

[Keith Black]

Does anyone have any experience with the "Custom Electronics, Perfect
Switch"? This is a switch/regulator combo. I recently purchased this switch
but don't really know of its reputation.

Thanks,
Keith


----- Original Message -----
From: "Tony Stillman" <tony at radiosouthrc.com>
To: <discussion at nsrca.org>
Sent: Monday, March 24, 2003 5:24 PM
Subject: Re: Re:switch failure


> Wayne:
>
> Futaba now has a HD switch, but the JR is very good also.  If you want the
> regulator type, ours has a good track record!
>
> Tony Stillman
> Radio South, Inc.
> 3702 N. Pace Blvd.
> Pensacola, Fl 32505
> www.radiosouthrc.com
> 800-962-7802
> ----- Original Message -----
> From: "wgalligan" <wgalligan at cnbcom.net>
> To: <discussion at nsrca.org>
> Sent: Monday, March 24, 2003 2:10 PM
> Subject: Re:switch failure
>
>
> > Thia is a rather an odd instance.  I will recharge the battery and check
> again.  It is not possibLe to hook this MPI up backwards.  Anyway I will
be
> sending you my Futaba PCM reciever as the antenna got jerked out and got
> sprayed with fuel.  Perhaps you could recommend a good h.d. switch Tony.
> >
> >
> > > Wayne:
> > >
> > > I have not heard of a problem like this with anyone's regulator!
There
> were
> > > a few failures of the Oddino unit, but it would just not turn on.  I
> don't
> > > know of any that failed in the air.
> > >
> > > Tony Stillman
> > > Radio South, Inc.
> > > 3702 N. Pace Blvd.
> > > Pensacola, Fl 32505
> > > www.radiosouthrc.com
> > > 800-962-7802
> > > ----- Original Message -----
> > > From: "wgalligan" <wgalligan at cnbcom.net>
> > > To: <discussion at nsrca.orgdiscussion@nsrca.org>
> > > Sent: Monday, March 24, 2003 10:06 AM
> > >
> > >
> > > > I had an unfourtunate mishap yesterday and lost my Prophecy.  Come
to
> find
> > > my redundant or failsafe switch failed on me.  I was using a MCI
Miracle
> > > swith that has a regulator on it and has mechanical fail safe if
switch
> > > breaks down the system is on till the battery is unplugged. I found
out
> when
> > > testing the battery to make sure I had juice.   Through the battery
lead
> I
> > > had 6.5v and at the charge plug I had 6.5 but when tested through the
> > > receiver end of the switch I had only 4.2v.  Below the recivers
voltage
> > > threshold.  Went into pcm lock up and throttled down and into a slow
> spiral
> > > death.  At least the throttle came down by pcm failsafe.  SO it
appears
> the
> > > regulator side of this switch went bad.  SO Much for failsafe.  Has
> anyone
> > > heard of such failure on these types of switches?  And is it really
> > > neccesary to voltage regulate a 6volt system.  I know when peak
charged
> the
> > > pack is at 7 volts on an expanded meter.   I have recently gone to
> 1500mil 4
> > > cell pack on my new plane to eliminate the regulator part.
> > > >
> > > > Wayne
> > > > =====================================
> > > > # To be removed from this list, send a message to
> > > > # discussion-request at nsrca.org
> > > > # and put leave discussion on the first line of the body.
> > > > #
> > > >
> > > >
> > >
> > > =====================================
> > > # To be removed from this list, send a message to
> > > # discussion-request at nsrca.org
> > > # and put leave discussion on the first line of the body.
> > > #
> > >
> >
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#