Center of loop

[don szczur]

Thank you very much!

Don
  -----Original Message-----
  From: Rcmaster199 at aol.com <Rcmaster199 at aol.com>
  To: discussion at nsrca.org <discussion at nsrca.org>
  Date: Thursday, March 20, 2003 9:17 PM
  Subject: Re: Center of loop


  In a message dated 3/20/2003 9:09:28 PM Eastern Standard Time, dszczur at maranatha.net writes:



    Subj:Center of loop 
    Date:3/20/2003 9:09:28 PM Eastern Standard Time
    From:dszczur at maranatha.net
    Reply-to:discussion at nsrca.org
    To:discussion at nsrca.org
    Sent from the Internet 



    Center maneuver, pull 45 degrees, 7/8 outside loop to verical, two point
    roll up, exit upright.

    Where is the center?  P03 Aresti sequence shows center is the loop center,
    IAC/full scale says center is the middle of the 45 degree line.  By pattern
    definition, the center of whole maneuver is  maybe the vertical up line-
    which is it?

    Thanks,
    Don


  Don,

  There are several elements but only three parts, the 45 deg up line, the 7/8 loop, and the vert w/ 2 pt roll to upright. I believe the IAC/full scale is correct= the middle of the 45 deg up line.

  Matt Kebabjian 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030321/afb29e80/attachment.html