Focus Canopy Painting

[s.vannostrand at kodak.com]

Good point, Tony.  I wasn't picking on you.  I just used your name because 
you live in a southern climate and are therefore MORE credible on this 
topic than someone living in a place where summers are 80 degrees.

--lance





"Tony Stillman" <tony at radiosouthrc.com>
Sent by: discussion-request at nsrca.org
03/21/2003 08:30 AM
Please respond to discussion

 
        To:     <discussion at nsrca.org>
        cc: 
        Subject:        Re: Focus Canopy Painting


I'm sure this can happen, I just have not had the problem.  What I was 
trying to make sure people understood was that you don't need very much 
tinting, just a little to "grey" it some and the canopy will then become 
visible in flight, while still allowing some detailing in the canopy area 
for those that like to do that sort of thing. 
 
 
Tony Stillman
Radio South, Inc.
3702 N. Pace Blvd.
Pensacola, Fl 32505
www.radiosouthrc.com
800-962-7802
----- Original Message ----- 
From: s.vannostrand at kodak.com 
To: discussion at nsrca.org 
Sent: Thursday, March 20, 2003 5:26 PM
Subject: Re: Focus Canopy Painting


I have to back up poor Bill.  It appears no one has seen a problem with 
melting canopies, even Tony Stillman from Florida.  However, I had the 
smoke tinted canopy from a giantscaleplanes.com Edge 540 melt and my 
friend with a 33% Aeroworks Edge had his black canopy literally collapse 
here in Texas.  Both these happened before the dog days of summer.   
  Maybe some plastics are weaker than others, but there is no doubt that 
this can be a problem in Texas.  In both cases, new canopies with lighter 
tinting worked fine. 

I'm glad no one else has experienced this.  It's no fun to see that happen 
to a brand new model. 

--Lance 




WHIP23 at aol.com 
Sent by: discussion-request at nsrca.org 
03/20/2003 03:27 PM 
Please respond to discussion 
        
        To:        discussion at nsrca.org 
        cc:         
        Subject:        Re: Focus Canopy Painting



In a message dated 3/20/03 9:34:11 AM Pacific Standard Time, 
av8tor at flash.net writes:


I've painted the inside of canopies pure black (not tinted) and never had 
one melt or deform in anyway.  I use to take black Sig Dope and brush the 
inside of the canopy.  From the outside of the canopy it shines as if it 
were molded black and brush marks wouldn't show as the outside clear 
plastic acted as a clearcoat without the mess.... 


Trust me, if you paint it black and set it out in the sun it will get HOT, 
some plastics may handle it better than others, but it will get hot, I'll 
bet so hot you can't touch it.  I've done it and got away with it, but 
I've also seen them melt/deform so be careful.  The shame of it is that I 
like the looks of a black canopy, both on the ground and in the air, but 
having seen a couple deform I've decided against black.  Ya' paints yer' 
canopy and ya' takes yer' chances.

Bob 


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030321/c44e7608/attachment.html