Cutting Ailerons - Preferences

[David Flynt]

I mark the cutouts on top and bottom, and then use an exacto blade with a
straight edge.  I am careful to angle the exacto blade so that it leaves
extra foam on the cut.  Then I clean up the cutout and the aileron with a
long sanding bar to produce a flat, square surface.

David Flynt

-----Original Message-----
From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]On Behalf Of Brian Young
Sent: Thursday, July 31, 2003 9:29 AM
To: discussion at nsrca.org
Subject: Cutting Ailerons - Preferences


Just curious how everyone cuts their ailerons out and
preferences.

Bandsaw vs. mark and cut both sides with razor saw.

Thanks,


=====
Brian Young
Tulsa
b4598070 at yahoo.com
918-745-6046h
918-838-0900w

__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com
=====================================
# To be removed from this list, send a message to
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#