OS 1.40 bearings

[Dave Smith]

Keith:    Why not pose this question to Bill Baxter,head of the O.S.Service department?
You can reach him via RC Universe,in the O.S.Engine portion where various manufacturer's reps answer questions about their particular product.
This will also ensure a fair bit of worldwide publicity.

Dave
  ----- Original Message ----- 
  From: Keith Hoard 
  To: discussion at nsrca.org 
  Sent: Tuesday, July 15, 2003 1:04 PM
  Subject: Re: OS 1.40 bearings


  Has anyone, especially someone who is sponsored by OS, talked to them about the rear bearing problems with the OS 1.40?  Is there anything they can or will do?  Is O.S. working on a solution?  


  Keith L. Hoard
  Cordova, TN
  khoard at midsouth.rr.com

   While President Bush was ...[at the G-8 summit in Evian, France], a lot of protesting. People throwing rocks, breaking windows. Great, now the French start fighting. ....   - Jay Leno


    ----- Original Message ----- 
    From: Dave Smith 
    To: discussion at nsrca.org 
    Sent: Tuesday, July 15, 2003 10:19 AM
    Subject: Re: OS 1.40 bearings


    Wayne:  I have run .61's,with both seals in, and only one seal in,and it made no difference.
    I suspect it would be the same with the 1.40, BUT if a seal should let go,it would be hard on the piston/cylinder assembly.
    I never removed any grease.  It will be gone after a run or three.

    Dave


      ----- Original Message ----- 
      From: Wayne Galligan 
      To: discussion at nsrca.org 
      Sent: Tuesday, July 15, 2003 11:49 AM
      Subject: OS 1.40 bearings



      After extracating the bearing last night my suspicions where confiremed.
      The bearing was rusty and was rather rough.   New bearings from Purvis going
      in tonight..  BTW $14.95 ea for bearings by Bearings liimited #61904-2RS.

      Do you guys remove the seal or leave it in?  I have heard of doing it both
      ways.

      Wayne

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030715/c105cdee/attachment.html