OS 1.40 bearings

[Dave Smith]

Wayne:  I have run .61's,with both seals in, and only one seal in,and it made no difference.
I suspect it would be the same with the 1.40, BUT if a seal should let go,it would be hard on the piston/cylinder assembly.
I never removed any grease.  It will be gone after a run or three.

Dave


  ----- Original Message ----- 
  From: Wayne Galligan 
  To: discussion at nsrca.org 
  Sent: Tuesday, July 15, 2003 11:49 AM
  Subject: OS 1.40 bearings



  After extracating the bearing last night my suspicions where confiremed.
  The bearing was rusty and was rather rough.   New bearings from Purvis going
  in tonight..  BTW $14.95 ea for bearings by Bearings liimited #61904-2RS.

  Do you guys remove the seal or leave it in?  I have heard of doing it both
  ways.

  Wayne

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030715/90ee906f/attachment.html