THRUST WASHER

[Wayne Galligan]

Cass, 

 I have made a puller for the ST2300 and the new MIntor 1.70 thrust washer.   Very simple and effective.  Go to my photo section at this link for a clear shot of the puller or email me for some photos.

Drill two holes and tap for 6-32 bolts.  Use a piece of hard aluminum or steel  about 1/8x3/4x1-1/2  and drill a hole slightly larger then the crankshaft in the center.  Drill 2 holes the same distance apart as in the thrust washer large enough for the 6-32 to pass through.  Put the prop nut on the shaft set the puller over that then insert 6-32 bolts. Tighten equally till washer pops off.

http://www.rcuniverse.com/gallery/showphoto.php?photo=13229&papass=&sort=1&thecat=500

Wayne Galligan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030703/596f6d46/attachment.html