OS Piston Pin

[Troy Newman]

Sorry...TDC I mis-spoke...Sorry I run YS........But it will come apart with piston-conrod assembly intact


TN
  ----- Original Message ----- 
  From: Verne Koester 
  To: discussion at nsrca.org 
  Sent: Wednesday, July 02, 2003 12:04 AM
  Subject: Re: OS Piston Pin


  Steve,
  I've got the sleeve out but I can't get the rod off the crank pin to save my life. The piston is at TDC. Troy's all wet about doing it at BDC. The groove machined in the case won't allow the rod to slide off the crank pin. I assume that when you were talking about tapping the backplate on a wood block, you were describing how to get the rear bearing out. My problem is getting the piston and rod off the crank. Just won't go. I get it about 3/4 of the way off and then it's stuck.

  Verne


    ----- Original Message ----- 
    From: Patternrules at aol.com 
    To: discussion at nsrca.org 
    Sent: Tuesday, July 01, 2003 11:22 PM
    Subject: Re: OS Piston Pin


    Verne pull the sleeve out then the piston and rod will come out together then you can push the pin out from the other side, just done mine this morning, the Webra has the threaded pin.

    Steve Maxwell 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030702/7fb588c3/attachment.html