Correct Part number for OS 140RX rear bearing needed (non EFI)

[Ihncheol Park]

If the seal has to be removed, why the EFI rear bearing has the seal?
Also, what kind of seal is that? Plastic or metal?
If the bearing is 100% sealed with plastic, I understand the removal of the
seal for lubrication, but if they are metal seal or shield that do not seal
100%, I think it is better to leave them since the bearing will be lubbed.
Am I right?

Ihncheol
  -----Original Message-----
  From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On
Behalf Of Patternrules at aol.com
  Sent: Sunday, February 23, 2003 3:51 AM
  To: discussion at nsrca.org
  Subject: Re: Correct Part number for OS 140RX rear bearing needed (non
EFI)


  I bought my bearings from Boca Bearing as a set, you have to REMOVE  the
seals when you get them the only seal that you don't remove is on the front
bearing on the thrust washer side, the cheapest bearing is the all you need
part #ENK-010.
http://www.bocabearings.com/hobby/hobbyguide2.cfm?manufacturer=72

  Steve Maxwell
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030223/783533c2/attachment.html